The X-09 uses sophisticated computer security and makes dialing much easier than that of traditional combination locks. The microprocessor in the lock recognizes a number as part of a combination when you change dialing direction.

The Lock On Back Cover (LOBC) feature provides a locking mechanism that locks the back cover in place after installation. The design is such that the back cover cannot be removed without visible damage unless the combination is known, regardless of whether the lock is locked or unlocked

The user should dial with complete, full wrist turns. Stopping to regrip produces pauses in dialing activity. This helps the X-09 distinguish between human and robotic dialers.

An X-09 lock will initiate a timed lockout of 3 minutes when ten consecutive wrong combinations have been dialed. Each additional unsuccessful attempt to open the lock will initiate another timed lockout. If the number of consecutive unsuccessful attempts reaches fifteen, the timed lockout increases to 4 minutes. The lockout period is only timed while the lock is powered. To keep the lock powered until the timed lockout has expired, turn the dial every 30 seconds. A successful opening resets the error count.

If the door of your container is shut and the X-09 is accidentally locked with the Change Key stillinserted in the back of the lock, you can recover with procedure mentioned in this manual.

Following are the Contents of Operating Instructions for X-09: Type 1F High Security Electronic Lock:

  • INTRODUCTION
    • Lock On Back Cover
  • DIALING THE X-09
    • Dialing Methods
    • To Power the Lock
    • Dialing A Combination
  • OPEN AND CLOSE THE X-09 (FACTORY COMBINATION)
    • To Open the Lock (Using the Factory Combination)
    • To Close the Lock
  • X-09 LOCK SETUP
    • Set Operating Mode and Change Combinations
    • If You Lock the Change Key in the Safe
    • USING THE X-09
    • Single Combination Mode
    • Dual Combination Mode
    • Supervisory/Subordinate Mode
    • Correct Method of Closing/Relocking Container
  • AUDIT FEATURES OF THE LOCK
    • To Check the Number of Successful Openings
    • To Check the Number of Unsuccessful Attempts
  • GUIDE TO SYMBOLS